Vpacket 6100 SERIES Instalační příručka stáhnout pdf (Strana 103)

Acme Packet 6100 Hardware Installation and Maintenance Guide 95

Caution To prevent damage to the optical lens, Acme Packet

recommends that the protective dust cover stay on the optical

transceiver port when the 10GigE physical interface card is not

cabled.

Removing an Optical

Transceiver

To remove the SFP+ transceiver from an NIU transceiver port:

1. Unplug all 10GbE fiber optic cables from the optical transceiver to be

replaced.

Figure 6 - 127. NIU Transceiver Port

2. Pull the bale clasp latch out and down. It will pivot downwards on its

hinge.

Figure 6 - 128. Lowering the FSP+ Bale Clasp Latch

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 127 128

Oracle Acme Packet 6100 1
Contents 3
About This Guide 7
Revision History 8
1 Safety 9
Electrical Safety Precautions 10
Battery Warning 10
ESD Safety 11
2 Component Overview 13
System Processor 15
System Control Panels 15
LINK ACT LINK ACT 17
Network Interface Unit 18
Figure 2 - 19. USB Port 19
Figure 2 - 20. Console Port 20
Figure 2 - 22. Alarm Port 21
Table 2 - 2. Alarm Levels 21
Network 22
Management Ports 22
Signaling and 23
Media Interfaces 23
Power Components 24
Power Supply 25
Redundancy 25
Cooling Components 28
3 Graphic Display 31
Display Modes 32
Graphic Display Menus 32
BOOT PARAMS 34
ENVIRONMENT 36
4 System Installation 39
Pre-Installation Guidelines 40
Mounting Installation 41
• Nut Bar (4) 43
• Mounting Spacer (2) 44
Installing the 45
Equipment Rack 45
Slide Rails 45
Chassis Flanges 49
Chassis in the 51
Center-Mount 52
Hardware 52
Fan Module Installation 54
Grounding Cable 55
Installation 55
AC Power Cord 56
DC Power Cord 58
Cabling the Acme Packet 6100 59
Figure 4 - 77. Console Port 60
Management 61
Network Ports 61
Media and 61
Signaling Network 61
Interfaces 61
Cabling for HA Deployments 63
5 Startup 65
User Access Verification 66
Password: 66
Formatting the 67
Solid State Drive 67
6 Maintenance Introduction 69
Acme Packet 71
Replacing an NIU 74
Chassis Removal 75
NIU Removal and Replacement 79
Replacing the SSM3 Module 82
Pre-Installation 83
Guidelines 83
Removing the 84
SSM3 Module 84
Installing SODIMMs 86
SODIMM(s) 88
Installation Tools 91
Figure 2 - 33 Left rack ear 93
Removing and 95
Replacing the 95
Media Cables 102
Fan and Filter Maintenance 106
Install Individual 107
Maintaining the 108
Cooling 108
Components 108
Hardware and 112
Environmental 112
Environmental Sensor 113
Link and SDP 114
Management Ethernet 115
Link Alarms 115
7 Specifications 117
Electrical Specifications 118
Environmental Specifications 119
Connector Specifications 119
Specifications 120
8 Glossary 121

Komentáře k této Příručce

Žádné komentáře

Vpacket 6100 SERIES Instalační příručka Strana 103

Komentáře k této Příručce